Lock nuts requiring a keyway (inch)
Locking plates engage a keyway in a shaft or adapter sleeve and are attached to the side face of the nut by two bolts secured with locking wire. A locking plate consists of a plate, two hexagonal head bolts with drilled heads and lock wire to secure them.Position the locking plate in the keyway. Tighten the nut further, if required, to align the holes in the plate with the holes on the side face of the nut, making sure that the plate maintains its position in the keyway. Screw both bolts into the side face of the lock nut and tighten them.
We offer a wide range of Lock Nuts and Washers. Contact us with your enquiry or use the Product Table below to find detailed information on a nut and washer. Lock nuts requiring a keyway Lock nuts with integral locking Precision lock nuts Locking (lock) washers are found on the above pages.
- skf AN 40 Lock nuts requiring a keyway (inch)
- Standard
- 22300
- skf N 028 Lock nuts requiring a keyway (inch)
- Round
- Normal Duty
- skf N 500 Lock nuts requiring a keyway (inch)
- 260 mm
- Maximum of +120
- skf N 026 Lock nuts requiring a keyway (inch)
- 5 in
- 9001:2008 &
- skf N 024 Lock nuts requiring a keyway (inch)
- Non-Expansion Bearin
- 25/32 in
- skf N 068 Lock nuts requiring a keyway (inch)
- 120 N/mm²
- 45 mm
- skf N 022 Lock nuts requiring a keyway (inch)
- 190 mm
- 28.829 mm
- skf N 064 Lock nuts requiring a keyway (inch)
- Round
- Lubrication Fitting
- skf N 060 Lock nuts requiring a keyway (inch)
- Uncoated
- 100